To configure legacy inter-VLAN routing, start by configuring the switch.
As shown in the figure, router R1 is connected to switch ports F0/4 and F0/5, which have been configured for VLANs 10 and 30, respectively.
Use the vlan vlan_id global configuration mode command to create VLANs. In this example, VLANs 10 and 30 were created on switch S1.
After the VLANs have been created, the switch ports are assigned to the appropriate VLANs. The switchport access vlan vlan_id command is executed from interface configuration mode on the switch for each interface to which the router connects.
In this example, interfaces F0/4 and F0/11 have been assigned to VLAN 10 using the switchport access vlan 10 command. The same process is used to assign interface F0/5 and F0/6 on switch S1 to VLAN 30.
Finally, to protect the configuration so that it is not lost after a reload of the switch, the copy running-config startup-config command is executed to back up the running configuration to the startup configuration.